G-Code Tool Path Generator for for Trimming Stock With End Mill

This calculator will generate a G-Code tool path for trimming stock with an end mill.The Z Origin is the top of stock. We trim by stepping the tool in the x direction.

Title
Units millimeters
inches
Direction of Trim +X(Postitive)
-X (Negative)
Tool Diameter
Stock Width
Stock Depth
Trim Width
Trim Step
Feed Rate (units/minute)
Retract Distance (from top of stock) (units)
Water Level Sensor


© Copyright 2019 Daycounter, Inc. All rights Reserved. There is no guarantee for any information on this website. Use at your own risk.